Tire removal machine, also called tire removal machine, tire removal machine. Make the car maintenance process can be more convenient and smooth removal of tires, there are many kinds of tire removal machines, pneumatic and hydraulic two kinds. The most commonly used is the pneumatic tire removal machine. The following is a small series for you to bring the novice tire machine tire skills, hope to help you!

Tire dismantling machine is a necessary repair equipment for each 4S shop and automobile repair factory and tire shop. When using tire dismantling machine in automobile maintenance, there will be some tips.

1, for the tire top rubber is good but soft and thin tires: when the shovel tires slip, you can slightly lift the shovel control pedal, at the same time push the tire inside, confirm the shovel mouth contact with the tire mouth, and then rely on the leg or hand to prevent the tire from falling back, and then step on the control pedal, it is easier to shovel the tire.

2. For sports car tires with long time: tires are subjected to internal air pressure for a long time, and the heat generated by the friction between the tires and the ground leads to the adhesion of the tires with the underwire. When it is difficult to shovel under the wind shovel, you can dissolve the detergent in water first, brush some solution at the lip and the rim with a small brush, and then shovel the tire with the wind shovel after the solution penetrates into the gap between the lip and the rim.

3, for the tire with hard mouth: it is better to choose the trolley spring plate when picking the tire, and the homemade extended crowbar is easier to pry the tire mouth to the bird head. When the tire is on, press the tire belly with both hands, when the difference is about 200mm, the tire mouth is at the most tight place, press the tire belly with the right elbow, at the same time, the left hand is the right hand, push the tire clockwise, can prevent the motor and three

Steps for removing and assembling tires

Open the lip, open the lip

Main points: Unloading valve core, unloading main points: unloading valve core, unloading balance block; Tire lip lubrication, balance block; Tire lip lubrication, diagonal tire press Diagonal tire press the use of skid bars

Pry bars are used for tire removal

Use of disassembling head

Tire installation

Lock the wheel on the turntable, lock the wheel on the turntable

Place the tire edge on the dismantling machine, place the tire edge on the dismantling machine, the left end up, the same, the left end up, while depressing the fetal belly

Keep the belly down.

Lubricate the wheel with a strong soap solution, lubricate the rim with a strong soap solution, rotate the disk clockwise, rotate the disk clockwise by the edge, so that the tire edge falls into the wheel tower